User Instructions:

For a flush rivet effect:
1. Draw the panel lines on the model with pencil or pen.
2. Peel a rivet stencil from the sheet keeping the dots attached to the stencil tape.
3. Lay the stencil over the line and rub with finger to make contact with surface.
4. Lift one end of the tape & peel back the tape over itself.
5. This will leave the dots on the surface.
6. Prime and paint over the dots.

For a domed or raised rivet effect:
1. Draw the panel lines on the model with pencil or pen.
2. Peel a rivet stencil from the sheet.
3. If some of the dots do not release, stick and peel them off on a sheet of glass.
4. The dot can be removed from the glass with a razor blade.
5. Lay the stencil over the line and rub with finger to make contact with surface.
6. Dab undiluted Titebond Wood Glue into the holes.
7. Before glue hardens, slowly lift tape off the surface at 90 degrees to the surface.
8. Allow glue to dry until transparent.
9. Prime and paint.

To add a panel line next to the row of rivets, click here.