If you have not worked with foam before, it is strongly recommended that you read the How To section first.
Do not discard any foam pieces that came with the kit, until after the construction is finished.

Wowplanes kits are "builder's kits". We assume that the builder has at least an intermediate skill level in building RC flying models and has built kits and ARFs before in balsa, if not in foam. The objective of this manual is to illustrate the features and construction techniques that are unique to this model.

It is not the intent of this manual to show the basics such as installation of motors, radio, servos, linkages, etc. which are common to all models.

Wowplanes kits lend themselves to finishing the model in multiple ways. The model may be left as bare foam and painted with foam safe paint, covered with low temperature heat shrink covering, fiber glassed and painted, sheeted with balsa and painted, or use our revolutionary Liquid Sheeting product.

Before you start building it is recommended that you decide what option you plan to pursue. Depending on the finishing option, you may have to alter the sequence of construction outlined below. e.g. if you plan to sheet the model with balsa, it would be easier to build and sheet the individual sub-assemblies before assembling the whole plane.

2.0 Fuselage

3.0 Ventilation

4.0 Wing Mount

5.0 Horizontal & Vertical Stab

7.0 Hardware Inatallation

Alternative hardware installation

HAPPY LANDINGS!!!!